3/4" Water Tight Connector, For Underground Feeder Cable, Die Cast Zinc, Use To Terminate & Seal Type UF Cable To Threaded Entry Of A Watertight Enclosure.
5 pack, conduit hanger with carriage bolt & nut, for 3/8-1/2" rigid & 1/2" electrical metallic tubing, use to secure & suspend rigid conduit, imc electrical metallic tubing or pvc conduit from overhead supports, slotted carriage bolt frees both hands for installation, each part is stamped with trade size markings.
Conduit Size-EMT (inches) 1/2
Conduit Size-Rigid or Pipe (inches) 3/8 -1/2
Material Steel
Finish Galvanized
Can Be Used for Either Vertical or Horizontal Installation
6HTB Series Have a Built-in Nut so There are Less Parts to Handle or Drop.
10 pack, 3/4" 2 hole 20 gauge steel strap, for rigid snap on type, use snap on straps provide easy mounting to support rigid & imc conduit as required by the nec where higher load bearing supports are desired, straps are marked with trade sizes for easy identification.
1" beam clamp, malleable iron, used to clamp on a beam, girder or other structural member to provide a mounting base for the attachment of conduit hangers, either directly or by means of threaded rod, csa approved.
1/4"-20 threaded openings
Fits flanges up to 15/16" thick
Supports threaded rod, threaded brindle rings and electrical boxes
Single gang, ent quick connect blue smurf switch & outlet box, 3" x 2-1/4" x 3" with three 1/2" knockouts, 16 cuin, for electrical non-metallic tubing.
Produced From High Heat Resistant Engineered Plastic Material
New Work Ceiling Box With Captive Nails, Grounding Lug & Screw Attached, 20 CUIN Capacity 3/0 - 4/0, 6 Integral Clamps, Fixture Spacing For 2-3/4" - 3-1/2", Combination 4" Diameter x 2-1/4" Depth, For Light Fixtures & Junction Boxes, Not For Use With Ceiling Fans.
